Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
really thankful for ur advice...i already have designed one pid and is getting simulated individually...but my project consists of modules a counter,pid and pwm...and when i am trying to link the three modules i am getting it compiled successfully but i am not getting the output of pid...
I am doing a project on ic design for speed control of a dc motor..so plz help me with a verilog code pid controller..where i can input the eroor value and get the ouput as my desired value...thankss in advance
here i am adding the code for 3 modules counter,pid and pwm...plzz help me to link these three modules....in such a way that i want the output of counter to be given as the error signal input of pid(e_in) and the out put of pid (u_out) as the the input of pwm(switches)....plzz help....thanks in...
i am doing a project on designing an ic for controlling the speed of a dc motor . the main modules in my project are pwm ,encoder,counter and pid..
i have generated the codes for counter, pid and pwm seperately but when i try to link it ..i am not getting it right ...plz help me..
these are my...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
