Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Actually There are so many areas like O.S scheduling Micro-controller Architecture memory the process mgt development.
choose the area then I can help you with the topics
the best way to enter is start with 8051 book by mazidi. learn about basics of micro controller,
Then after understanding the concepts of 8 bit start with 32bit ARM, there no need to study any 16 bit stuff.
in ARM start with ARM7 get a board the ARM 9 let me know if you need any further help...
Re: Simple client or server app on embedded ARM running linu
there are some demo examples on WROX-beginer's linux programming ed-4
these will give you some good idea of socket programming
Re: LPC2148
there is an issue of your board not able to communicate make sure your board resets well. i.e. reset ckt is working properly.
After that go throu the manual of flash magic if this does not work le t me know
Re: What is firmware
As we all know internet working
internet explorer is at application layer
TCP/IP Stack+Ethernet driver = Firmware
I hope this makes it clear
hi,
I think it wont work because your laptop need to understand what is coming through the parallel port which will be provided by the parallel port driver coming along the emulator.
Good Luck
Dear bobi,
I have already added R+C snubber to a snubberless TRIAC(BTA12800CW) can this senario cause any kind of overheating?
One more thaught the transient response of inductor is short ckt, so can frequent motor on and off can be the root cause?
if yes any way to replicate the senario...
I know I am asking for too much but could you please describe your senario.
So that we can corelate and probably come to some conclusion.
This can be a great help to community
Dear Bob,
Thanks for the reply I am driving a 150w single phase inductor motor.
Just to remind you there is a snubber accross the TRIAC (TRIAC is snubberless) for extra protection.
Is it possible that R+C snubber can short??
Hi,
I am using a BTA12800 CW TRIAC which is a snubberless TRIAC + snubber ckt.
TRIAC blown out and got short that too after some time,
Is there a possibility that snubber may cause overheating?
What else can be a possible reason?
Please help me with all the parameters I should check?
Let...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
