Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Issue in using I2C Protocol while reading Hardware ID of CCS811
Hi ,
I am integrating CCS811 with STM32L072xx. I am reading the Hardware ID of it, so for the same I am monitoring the clock pulses on the SCL line. When the Hardware ID has to be received on SDA line, there is a gap between 8th...
On the serial monitor we are getting the ID as 0x80 but, on CRO the hardware ID it 0x81, with a gap between the 8th and 9th pulse, and we are missing the NAK signal as specified in the Application Note.
We are currently using this function to read the register 0x20:
HAL_I2C_Mem_Read(&hi2c1...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.