Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, thank you for clearing my confusion. The pot is rated for 5W.
I understand what you are saying. I will check again today and make sure I didn't miss any points you mentioned.
I have also checked by increasing the input voltage from 5V to 10V DC by connecting it to a test load, nothing changed. Also, since I am making a constant current circuit, the change in load shouldn't affect the circuit.
Please correct me if I am wrong, with any input more than the nominal...
Hi, sorry for the confusion.
The laser I am using is not concerned with the voltage as long as the voltage is below it's rated value (2.6V). However, I need to vary the current value from ~100mA-~850mA due to operational purpose, so, I used a 10 ohm pot (R4). I added the 1 ohm (R5) to keep...
Hi,
I am building a constant current laser driver using LM317T. I am attaching my schematic herewith. I have simulated the circuit and it works fine, however, when I am making the actual circuit on the board, it doesn't work anymore. I want ~100-850mA in the output and the circuit was designed...
That cleared it up. Thanks.
It is an optical device. It uses a DC signal for tuning purpose, however, since we don't have the manual/datasheet, we don't know the device ratings. There is a 'Lemo FFA.0S.250.CTAC' connector attached to the device to input the DC.
The device can be tuned in only...
Sorry for being a noob but what did you mean by 'used to connect'?
Also, I am using a common multimeter to measure resistance.
Just to be clear, one clamp of the meter to the pin and other to the connector metal should give me the resistance, right?
Hi,
I am new here, so this may not be the right section to post this. If so, please forgive my mistake.
I am confused about the purpose of the coaxial cable connectors. What part do they play electrically? Does it act as a ground to the male pin?
By connector, I mean the metal housing around...
Hello,
I am new here and I am not entirely sure if this is the right section to post this. If not, then please excuse me.
I have an electrically tunable bragg grating filter made by Highwave Optical Technologies. The problem is I do not have the datasheet/manual for this device. I was...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.