Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I used the IC base for ade.In the ckt, I used 10 pin headers to represent an IC base. for better understanding, I have attached my IC base photo.
Please go through the following link.
https://obrazki.elektroda.pl/8280470400_1489931872.jpg
I used 10 pin headers to represent ic ... I had a plan to solder IC on some IC base and I found one so according to that I designed this circuit.i have attached the image of my IC base so you can understand more clearly.
for the current channel, I followed ade 7753 evaluation board ckt diagram with CT. and same for voltage. rest of the ckt I made according to the data sheet of ade 7753. no change at all as they said I followed.
# include<stdio.h>
#include"lcd.h"
#include"display.h"
#include"spi.h"...
Hello, I am using ade7753 for my college project, I almost read all default register successfully. but I am facing very unique problem while reading VRMS an IRMS . when I gave input to Voltage Channel and current channel then i get proper voltage at VRMS but IRMS channel got stuck at 16385...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
