Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks sir for your reply,
what do you mean by other PCB package ? do you mean other software like eagle,kicad...etc ?
also is it possible to make the layout manually by putting transmission line between each lumped component or it's useless ?
Hello ,
how to generate proper layout from this schematic ? i need to make layout so i can export the gerber file.
Note : Both are the same just rearranged.
I got your point.
of course the power is fixed and i can not get the same result in lower inputs.
my idea was to make 2 different circuits, one with voltage multiplayer so i can get the desired voltage but in this case the current will be extremely low since i doubled the voltage.
the other...
Hello,
The following rectifier is working on 2.4GHz band with input power equal to 60mW which is approx equal to 17.5 dbm.
the results and schematic are attached below.
My question is :
How can enhance the circuit so i can make it give the same result or close to it with lower input power as...
Hello guys,
I have some questions about rectifier design which working on 2.4GHz band.
the Schottky diode which will be used will be HSMS_2850.
i am planning to to use charge pump to increase the voltage as well.
1- how to calculate the capacitor value in each stage ( what is the formula used)...
Hello, i am undergrad student and my final year project is about RF Energy Harvesting.
but i am facing problems by using ADS i did some schematics from different published papers but i don't know what kind of parameters should i use or even how to get the efficiency of the rectifier.
Also...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
