Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The I2C pins are not connected to anything else than the pull-up resistors so there is not another output stretching down the line.
I am not sure if I understand what you mean... do you mean that there could be some problems with the I2C peripheral?
I have tried to outcomment that line that checks the CR1 register and still no interrupt is generated and no start condition is seen on the pins.
As soon as I set the START bit a start condition should be seen on the pins and an interrupt should be generated. But nothing happens.
I have looked...
Why should someone just give you the code when you are not interested in learning anything?
1. Learn how a AD-converters works. Study!
2. Find appropriate schematic. Study it and understand it.
3. Translate to hspice code.
4. Simulate and verify.
If you get problem with 1-4 above, then come...
Hi!
I am new to this forum and seeking help. I am working on a PMBus compliance tester. PMBus extends SMBus which extends the I2C bus. 8-)
I think I have initialized the I2C peripheral on a STM32F103ZE correct. However, I cannot generate a start condition. I am using pull-up resistors and the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
