Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all,
I'm using the PIC32 USB starter kit2.
I was wondering how can I control the output (and input) voltage of the UART?
I've noticed that it is now 3.3V and would like to have a 5V.
Does anyone have suggestions..?
Thanks!
Hi all,
I'm having some synchronization problems with the UART.
I'm using the PIC32 USB starter kit2, connecting the UART1A outputs to a RS232 cable and to the computer trying to test my code.
My configurations are
#pragma config POSCMOD=XT, FNOSC=PRIPLL
#pragma config FPLLIDIV=DIV_2...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.