Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
C-Man I'll get that done as soon as i can bit busy at the mo only checking in cheers
PICO how do i check the res of an idividual pin must the pic b taken out of circuit or left in and powered up?
Cozturk What was the error u found on the datasheet it may help me.
Hey people, i've connected a MITEL 8870 DTMF decoder to port b of my PIC.When i transmit a DTMF the decoder should give 5V on its data vaild
and then the same voltage on it data outputs but i'm only getting 0.75 V on these outputs of the decoder.
When i remove the pic and test the...
thanks 2kostya2, that will help me a lot with the software.but i'm trying to get it built at the mo. i keep getting too much juice or too little going into the alarm (transistor aactivated NE555 astable + buzzer)
Thanks all the same though. 8)