Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Well, I just came from college but found a "show-stopper" fact.
ISOCAM can generate the HPGL instructions based on which tool(s) you have, in this case: router bits.
The problem is, that other students just broke the smallest router bit (about 0.4mm) and left only the 1mm one. Configured that...
First of all: YES I KNOW THIS THREAD IS ANCIENT, but as it appears in search engines I guess here is the best place to put the following information, to be the easiest way for people to find it. If any staff member thinks its reasonable to move the thread it's ok.
Well, we have such a machine...
Greetings! I've found this forum and I'm quite sure that as here you have a great community someone could give a hand ;)
Well, I've previously programmed a standard GLCD based on the samsung KS0107/0108 controllers. It had the typical 20 pin straight connector, but... recently I found an older...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
