Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i have set up the period is 100ms. if the time high is 1ms, how can i get the dc 0.05V? the voltage is average right?? (1ms/100ms) x 5V(amplitude of PWM)
it is right i was use rc low pass filter with 100Mohm n 10mF?
how to do it?please help me...
Added after 15 minutes:
my pwm amplitude is...
thanks all...
umery2k75,,can u explain detail how to produces the output as you wrote here...
my question now is, the output is in PWM, but how it will range the voltage from 0-10 because the amplitude of the PWM is still same..if i use 10v amplitude, and then 1 will use low pass filter, it is...
thanks for information given...
can you explain it in more details?
do you has done it before this?
if yes, can you share in detail how to complete my project?
i hope you can help me...
thanks..
my project is frequency to voltage converter using PIC.
but i dont know suitable PIC for my project..
i am also dont know how to complete this project..
the project is to read input frequency and give the output in voltage..
for example like below..
input (hz) / output (v)
100 /...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
