Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
ADC question
Hi Gents,
I have a question that might appear stupid to you experts.... Is there any relationship between ADC input voltage range and its sampling frequency?
Could you please advice some references? Thanks.
Nass
Hi a1919kimo,
Image problem is linked to mixer. In your case, I assume your IF=100MHz (RF-LO), the image will be at IM=800MHz folding in the same band than the wanted signal after downconversion (LO-IM). To remove the image your have to filter before the downconverter mixer.
Hope it helps.
Nass
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.