Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Sir I need to develop an RF receiver prototype as an interface between KNXTP bus and RF remote controls. I have done half of this i.e interfacing RF Receiver to cortex. Now i need to do the other half. and I think your question might be right, I might have miscommunicated.
I need to interface NCN5130 with KNX TP Protocol. I have attached an image below. Hopefully it is easy to understand. i have done the first part, that is interfacing RF Receiver with cortex. Now i need to interface cortex and NCN5130 and also NCN5130 with KNX TP.
Hello,
I need to interface NCN5130 with a EFM32 Zero Gecko 32-bit microcontroller, the industry’s most energy-friendly MCU based on the ARM® Cortex®-M0+ processor. I am having difficulty finding the .c and .h files for this NCN5130. Any help is appreciated.
Thank you.
Hello,
I need to be able to run my circuit for about 50 ms but it shows that the "time step is too small" in LTspice. I tried changing the "Solver" in tools to "alternate" but it works only for 1 ms.
Thank you.
The amplitude of the output varies with variable capacitance Cx at the input. I need to first get a ripple as shown in the uploaded image and then find a mathematical relationship between the input and the output of the filter.
I am using this topology for low pass filter sir. The AD633...
I have designed the filter for 20Khz frequency, with a gain of 2. Also i am not getting the desired output and the output i am getting at present is also not exactly twice than the input as it should be since the gain is 2. Do you think the filter output and the component values used are right?
I need to design a sallen key filter such that the output of the filter is a pulsating DC or ripple output when compared to the input. I tried implementing the below circuit but the output is not satisfactory. I am getting a sine wave instead of a pulsating dc or a ripple.
Frequency at the input...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
