Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Design a LDO with over Current Protection !
Hi Every One i try to design a LDO Linear Regulator with a Mosfet , i have draw this Schematics , What do you think about this Regulator ? i use an precision 1.2V reference Voltage (AD1580) and R4 R3 for Coarse and Fine Voltage , for current...
thank you , For the mosfet that i have chosed its only for simulation next in practice i will chose an adapted one , for a logic gate level what do you recommend ?
for zener i used the Resistor in parallal to vary Iz its good idea ?
@Easyrider83 i don't understand what you mean :roll:
good morrning ,
i currently work with a sensor that must heating them with two voltage 5v and 1,4v , the resistor of Heating equal to 33ohm , i have used this circuit with zener with 3,6v voltage and mosfet to switch bypass the zener and I want to know if it will be effective ?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
