Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
if you assume that I will create the symbol first then link the model to it, I want to know how can I link the spice model to the created symbol?
- - - Updated - - -
Yes, I use spectre simulator.
Dear all,
I would like to use spice model for one of the commercial ICs in cadence virtuoso then make a symbol for it. I read that i should create new cell view and past the model in it then simulate it using spectra.but what is the type and the view of the new cell view?
Regards
Thanks a lot, Bradthrad for your helpful replay. but, what about replacing the bipolar transistor by mosfet one?and what is the equation between the output frequency and the circuit parameters?
can you help me to answer the above questions?
- - - Updated - - -
Thanks a lot for this suggestion.
Hi guys,
I want to design a sinusoidal VCO circuit around 25mhz depends on varying one of its resistors.
It is prefered to be CMOS based and contains no inductor.
I read that the opamp based oscillators are unsuitable due to their limiting frequency.
Can anyone recommend a circuit for me...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.