Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by nagarajkumark

  1. N

    PIC32MX340F256H Crystal problem

    finally 1 mega ohm resistor connected across the OSC1 pin and OSC2 pin. it's working. thanks for your replies. NAGA
  2. N

    PIC32MX340F256H Crystal problem

    i found out that solution. but i want to know this is right or wrong. when i connect 100K resistor and 0.1uF capacitor connected in series across the OSC1 pin . It's working well. [/IMG]
  3. N

    PIC32MX340F256H Crystal problem

    Thanks for your reply. both load capacitance are same. no dry soldering. still now i soldered 10 numbers of PCB using this controller, but all board are same this problem in starting stage. After any physical interrupt its working perfectly all board. i want to know this which kind of problem. i...
  4. N

    PIC32MX340F256H Crystal problem

    Hi, i am using PIC 32MX340F256H. Crystal KDS 8 MHZ, load capacitance 22 PF in OSC1 and OSC2 pins. i have some problem in crystal OSC1 pin . when i the touch crystal OSC1 pin in multimeter probe or CRO probe, it's working good. otherwise its not working. after reseting the board its not...
  5. N

    sim548c module heating problem

    ok now i solved that problem. Audio circuit is the new problem in my sim548c module. can u give me any suggestion.
  6. N

    sim548c module heating problem

    hi anyone help me. i have one problem. now i am working in sim548c module. i did given to 5v to VCHG pin using lm2576 regulator, next connect the 3.7v li-ion battery to VBAT pin of the module. at the same time regulator and module is totally heated. what to do? u know that solution please reply...

Part and Inventory Search

Back
Top