Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
cadstar export
Yes, I had called cadstar distributor about IDF, and got answer that is not free.
And I found the third-party, Latimer, IDF translator maker.
But I could not download anywhere in site.
cadstar idf
Dear reader
I am trying to make 3D data from PCB using IDF.
Many of articles in this site help me make this.
And I have two artwork tools, allegro and cadstar.
I have had a good result from Allegro IDF export and Pro/E.
But I can not know how to export IDF from Cadstar.
I...
best electromagnetic simulation software
Im beginner in electromagnetic simulation. I read artcles below.
Many software are mentioned..
Ansoft HFSS, Agilent ADS, CST .... Etc..
I don't know,...which tool is suitable for beginneer.. and has best performance..
Anyone inform me about this...
Dear Reader
Do you have information of ECAD market share ?
It's many PCB Vendor. Everyone give suggesting of best schematic and pcb and simulation tools.
I think, one of the factor of the best tool is market share.
So if you have information of market, please reply message
Thanks
Do you have any Errata Report in code composer from your application or TI about below?
I meet mal-operations in our DSP(TMS320C31) application.
Therefore I don't understand why this mal-operation is occured.
// Code type 1
if((Var&0xF000) == 0x8000)
{
// do action 1
}
else
{
// do...
case tool vxworks
If you know good, ease to use, lower price and other strong points, CASE tools, recommand it to me.
I would like to use CASE tool with the new embedded project. But I don't know which tool is better.
So please recommand the CASE tool you think the best.
Thanks
Is there anyone hear or know the equipment can measure the EFT Noise and other noise in real site?
I have had some problems in Noise environment. Now I overcome the noise, but I can not find the noise source. So I would like to search the noise source in the site.
If you have idea of...
difference switch multiplexer
Dear Reader
Which device is better for analog channel switching?. I have used multiplexer(mux) for analog signal (the signal is weak... 10mV under) channel switching. Recently I hear, analog switch is better than mux.
But I have no experience about analog...
cadif format
Dear Reader
I am trying to translate to CADSTAR PCB to Allegro PCB using Camcad or other tools. But all tools do not has satisfied performance.
So I am trying to build new program for translations. CAdstar has text export format, PCB Achive.
And Allegro also has text format...
xilinx classics
Thanks for you comments.
But when I create a new project, I can not find any more except edif in design flow.
In my pc and ISE 4.2, Project properties has only edif design flow with spartan.
Thanks..
spartan-xl vhdl
Reader..
I install ISE 4.2 for spartan or spartan XL. Therefore, after installation, I can not find Schmatic and VHDL or Verilog method in ISE program.
What 's the fault in installation. Or How can I set Sch or VHDL method in ISE environment.
Please Help me for this.
Thanks..
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
