Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I'm currently simulating a Flipped Voltage Follower. I've ran a transient analysis (pulse wave) and the output seems to show large voltage spikes.
What could I do to remove this all together? or anything I could try adding to the circuit?
any help is appreciated. thanks!!
Hi,
This is just a question about design using LTSpice using only LV MOSFET's.
Supposed I have a signal between (1.2v-3.7v), I need this to be in the range of (0v-3.3v), so a DC shift of 0.4v down would do the trick. Would this be possible with just MOSFET's and a power supply of (0v-3.3v)?
1...
Hello,
When it comes to designing, simulating, and testing a newly designed circuit, I'm quite bad at it.
If I was to put it in a block diagram would it go like this:
[understand design requirement/limitation/constraint for specific application] --> [design circuit] --> [simulate/optimize]...
Hi,
Would anyone be able to help me out with a question. My lecturer in analog electronics likes to put trivial problems (with no explanation) for 'independent research and additional learning'
One that I can't figure out is: In Biomedical Implantable Application, specific circuitry are...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.