Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I have the same problem here! I dont khow where to start my design, I'm wondering if you guys could help me out with this?
I planning to design an analog section of 13.56MHz RFID tag.
tanx a lot..
try this it will work
.Probe Gmo(M1)
notice that M1 is the name of your MOS device
you can also plot Vth Vs Vgs or any voltage by using the code below
.Probe Vth(M1)
try this it will work
.Probe Gmo(M1)
notice that M1 is the name of your MOS device
you can also plot Vth Vs Vgs or any voltage by using the code below
.Probe Vth(M1)
vdd d 0 3
*****
r1 out d 10k
m1 out g 0 0 nmos l=1um w=50um
vin g 0 dc 0.9 ac 1
*****
.op
.tf v(out) v(g)
I've the same error
**error** element 0:v has been
referenced but not defined
can you help me?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.