Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: DXF and Netlist - please help
Thanks a lot for taking time out and posting the reply. I however found a way of doing it.
Here is what I did
1. Created a schematic in Layout
2. Generated netlist
3. Imported DXF in layout
4. Placed all the components on top of the DXF at the exact location...
Hi,
I have a situation in which I have the DXF File and the schematics which I have copied from paper into Capture and Created a netlist.
What I want to do is to create a board layout with components exactly in the same place as the original PCB and reroute the board as per the requirement...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
