Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Guys,, Any idea about the exact frmulae of epsilon calculation (ripple constant)... I have these 2 diffferent one, both of these are not giving the rightr results
and second one is without this absolute factor..
Which one is true>>>>???
So I am reading the content of direct CM synthesis at his time. I need your guidance for these lines:
The network can be directly connected between the terminating resistances Rs and Rl which, in general are nonunity in value. To scale the terminating impedances to 1 Ω, input/output inverter...
I have to implement this one
Now how can I make such coupling within range 0-1. Moreover, I am just unable to understand N- N+ non resonating nodes here in the matrix...
Thanks for the guidance.... its working..
Now, I want to done the couplings which are >1 in magnitude.. HOW can I make it possible??
Is the inductors supporting k>1 mag, are different than normally used??
I have used a discrete type inductor..
Thank you for the reply..........
But I further need guidance, how to change the remaining couplings?
I have done this L1=L1l L2=L2r1 with the K1, (attachment), but how to change remaining K2-K6 with such expressions? Also check the property window pane of the schematic.. Is that...
Well.......i have read your attachment work. Its some what clear to me that how a matrix effects the response, BUT, I have no idea how this MATRIX and then a RLC is generated from your example.
Is that sequense as mention in the attachment, same?
How you have conveted CM to a RLC network?(any...
I am working on inductive coupling b/w resonators (RLC) ,using orcad lite 16.6 tool. At this time I am unable to perform it properly, Is any one there to suggest me how to couple the resonators via inductors? I am using "K_linear" under analog library ,as coupling coefficient. The circuit layout...
if have foundout this tool @Dedale@ https://www-sop.inria.fr/apics/Dedale/
it can be used to findout coupling matrix from order, polynomials etc info. Any suggestions from your side.
I have'nt try this, but , want to confirm whether this coupling matrix can be later on translated to some...
Answers:
I have no tool at this time, for CM synthesis.
For simulation, I use HFSS.
No I cant analyze its spectrum
No, I cant understand the difference very well.
Well, I am following the referred papers and cameron book, and till now I have the knowledge about:
1. Basics of P E F,
2. how to generate P and F (unfortunately, not E at this time....for this I am further doing the literature review)
I have done this following steps given in an Cameron's...
@@@I am working on the directions mention in your most last reply.
Side by side I also want to know about the aattached image. What is its usage? I have just saw it from a literature but could'nt findout any further info. about it. It seem ias some matlab toolbox which can help us in doing the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
