Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hey everyone, I need some help here. I've so far writen the program as below and I've managed to get the hex file. I'm trying to download the program into a PIC18F452. FYI, I'm using a 40-pin enhanced start-up kit. When I try to download the file and click "start bootloader", the message "...
At the moment I've chosen a geared motor. It's a brush motor I suppose. The specs are here: http://www.cytron.com.my/usr_attachment/SPG30%20Spec.pdf As for the power, I will be using 12v DC supply from an rechargeable sealed acid lead battery.
---------- Post added at 11:33 ---------- Previous...
The IR sensor is a SHARP GP2XX series. Basically i need to use the ADC of the microcontroller since the sensor reads the the distance in analog form. It's takes a continuous distance reading with a range between 10-80cm. But i just want it to trigger at a certain range, say about 50cm...
I'm currently working on a project the uses an IR sensor to control the start and stop of a DC motor. The idea is to receive the input from the IR sensor through 1 port when the sensor sense an object, and output to start the motor through another port. I'm having trouble with the c codes. Can...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
