Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I plan to use regular car 12v fuses Link
im more of a "make it adjustable" type of guy but i could connect a scope across the fuse and have a look when i pull 25A and disconnect the fuse,
i wil return to this when i get time to do it
a reset push button on the circuitboard itself would be...
tanks for your reply. isnt this overcomplicated? in my case the fuse is mainly protecting internat short circuit it wil newer blow from over carge/discharge current as there are more fuses down the line
im looking for a circuit that can tell the state of the fuse, it seem like there is 2 ways...
the system is already 240vdc so its high enough, i could have 6 series strings but i went for 6 in paralell module banks to save on bms cost. all this have already been up to consideration thats why im asking about a circuit to sens the fuse state
hi thanks for answer
im missing the circuit, thats what im asking for.
transistors, led's, latch and reset switch have to be in the circuit.
im using a plc to monitor the whole system and it wil tell me if a fuse is blown somwhere and i wil physically go and look for the led witch is on.
if...
I can not wrap my head around circuit designing, it's highly annoying!
Could please someone help me to design the circuit I'm looking for?
And please I'm looking for a circuit not other solutions like microcontroller LED across fuse, etc.
So my issue:
I have 6 leaf modules in parallel 8.4v when...
thats more than what i was thinking.
here is a drawing to show what i was thinking,
offcorse it do not work bechause i do not have the knowlege to make it correct but the design or how to do should be possible this way.
240v is stepped down to 0v and 245v wil then be 5v, potentiometer is there...
hello
im looking for a circuit that can remove access power from a battery, but i can not find it anywhere.
im not that competent in designing circuits so i wil try in forum.
maybe someone have a circuit that i can use.
i did not ask about safety, i did not ask about other ways of doing this...
im not sure if you understood,
my load signal is just to tell the ignition what to do, advance timing etc.
i had a look at the signal and its a pwm for sure, i eaven got a video that show steady frequency and longer pulse when i step on the trottle.
its other comenication between the 2 ecu's too...
Its allways someone isent it put your nose on the big world problems, join the war against IS or something
This smal project will not harm anyone or anything!
My goal is to get back the oreginale air fuel ratio bechause modern fuels is mixed with ethanol and also ir runned true a reactor to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
