Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am about to buy silabs BGM13P BLE module as given in this linkhttps://www.mouser.in/ProductDetail/Silicon-Labs/BGM13P22F512GA-V2R?qs=sGAEpiMZZMsGelYiB%252bjhZoug4L%2fWODSM7Fx4KdEhVtKbmv0yCxCjZA%3d%3d But while reading the information on Silabs website for this module I came across this Radio...
Hi,
I am using NRF24L01+ as wireless communication medium. The NRF on PRX side interrupts MCU only once for recieved data. Although it sends ACK to NRF at PTX side. And I have also seen that this NRF at PRX side "discards" data recieved, by polling the registers. Same problem was faced by one...
Hi,
I am about to build this kind of PWM charge controller but using PIC MCU. But I am not getting how current is limited in this? In that instructable author says:"The amount of charging current is determined by difference between battery voltage and charge set point voltages". But how...
share your code with us, so that real solution can be given. And whihc dev board it is? Do check various configuaration settings like PWM, Timer1 OSCEN, OSC switch etc... Wrong setting of this bits can create various problems.
Actually this schematic was for motor control and I am using it for multilevel inverter by replacing Highside N channel MOSFET by P channel MOSFET. And yes my problem is solved.This is the modified schematic:
I am trying to work with PIC and GSM communication. In that as a notification after receieving SMS GSM sends string as:+CMTI: "SM",5.
So I want to copy that '5' in a char. But though copying it the value in the char becomes garbage value and not '5'. Here is the code snippet:
char SMSL; // this...
Hi incol,
If have used OP07 in more critical application than yours, its really very appreciable. And you use normal non inverting amplifier, it shall help for your application and set gain as according to your requirement.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.