Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I think I'm getting closer and thanks for the suggestions but I can't see how this helps for measuring current zeros. My TRIAC thoughts were to somehow determine current thru the device - again, I'm a TRIAC newby so this may/may not be possible.
I'm actually working on something that incorporates power measurement. Current can range from near 0 to 15 amps. The current transformer idea might work but was hoping to incorporate the components onto a PC board. I can probably do that with the transformer but I recall seeing somewhere the...
ssop 28 etch print
This is probably out of the league of the average hobby electro but one method I've used is to mill out circuits. Now, I happen to have built a mill to do that but I think there are some out there for the sort of $1200 USD range. It really comes down to a cost trade off. Over...
I have used both Atmel and PIC and both have merits and the community support is good. Lately I have leaned toward Atmel because of the ease when working with the boot loading flash parts. Also, I found the dev tools a little cheaper and better engineered - particularily when working in C. Just...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
