Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
@babatundeawe
Thank for the link. Its very helpful. I shall make my own calculations and check it with this site.
- - - Updated - - -
The PushPull on the site from the link has only one primary coil. My design is one with a centre tap. Can this be used with the same applet?
Or should i change...
@babatundeawe
As you see in the schematics the sg3525 is selfadjusting. I think the core is collapsing like you said in a previous post.
Do you have hf-transformer design software? Like the online poweresim?
The left side of the Hbridge is fed from a micro with 50hz. The right side of the bridge is fed with 28k8kHz PWM. 50Hz is used for timing, pwm for building the sine-wave. With the right two pole filter a true sine is created. thats working fine.
Can anyone help me with some hftransformer...
I have made the design like below.
The output of the H-Bridge is working fine. I only have to design the filter to filterout the hf components.
The problem is in the push-pull of the design. making 325V out of 14V4. Its working fine with the core i have got but it goes very slow to 325V and...
Hi Tpetar,
thanks for the pdfs. They are very helpfull. I will use parts of it. But I will let a microcontroller handel the pwm :).
I will let you know how its going on..
thanks again.
Hi tpetar,
I am currently designing a inverter from 12-15Vdc to 230Vac aprox. 25va and later on 80va.
I want to us a dc-dc boost converter to boost the input dc to 325Vdc. Then I want to use a microcontroller to make a PWM to make a sine @ 230vac 50Hz.
Im going to boost the 12-15 via a...
Mmmmmmmmmmm maybe a lightbulb was a poor example. :-(
I will draw up some schematics and let the board take a look at it. I hope some good suggestions are made... :grin:
@FvM: thx for correcting.
I have been reading this thread.... thx for pointing it out.
Im going to boost the 12-15 via a hf-transformer to 325V. I have contacts that can build them for me if I gave him the windings, amps, etc. Im thinking about aprox. 40kHz for the switching frequency.
This...
I know PI is for SMPS 85 to 230 Volt mains to low voltage dc. I know i build these in the past.
The thread you mentioned is not found?
Can you give the link again?
Hi Zasto,
thanks for your quick reply.
I know what you mean. I have build one for 25VA the way you mentioned.
For 25VA it is already a big transformer!!!! And for 80Watts its gonna be a whopper :lol:
Im going for lightweight.....
Do you have experience with a HF version?
Hi everyone,
I am currently designing a inverter from 12-15Vdc to 230Vac aprox. 80Watts.
I want to us a dc-dc boost converter to boost the input dc to 325Vdc. Then I want to use a microcontroller to make a PWM to make a modified sine @ 230vac 50Hz.
Can anyone give me a help on which boost...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.