Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
yes you can.
first,you should define within your design parameters like length, position etc..
then in the optimetric you should define the range of these parameters, and analyze.
there are too many steps to write it down, please rfere the tutorial examples for oprimetics, and i am sure you...
Hi,
when doing on chip measurements, the two ports may be very close to each other.
the isolation is to eliminate the coupling between the two port.
just place the two ports with the distance the device under test should be measured, and preform the isolation test.
Re: RF MEMS vs RF IC
Hi,
about advantage and disadvantage between them:
they are two different area, so you can't compare between them.
most of the RF MEMS subjects refers to passive devices, while most of RFIC is active devices.
about future vision, in my opinion any radio device should...
Re: HFSS Boundry?
Hi,
it is depends in the purpose of the boundry.
for an example, if you are looking for radiation pattern of antenna, use the radiation boundry.
They are two different boundaries.
Re: inductance question
Hi,
i saw this phenomena many times before, it is not a mistake.
my guess was that the inductance is decreasing as a result of the skin effect.
and after it increases because of the parallel capacitance of the net inductor model.
Hi,
When the number of passes increase it doesnt meen that the solution is going to be converged, sometimes it goes to the opposite way.
you may adapt hamidmoghaddas suggest,increase the number of passes.
dont warry about the convergence process, look just for the converged (last adaptive)...
Hi,
It's depending on the configuration you want to use the spiral (single ended or differential).
By connecting it with differential excitation you may use only one port between the spiral terminals.
by connecting it with a single ended excitation you need to define the ground reference...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
