Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
now , i create normal ECG wave signal.....i got p wave & t wave.....& battery supply ±9V , all my circuit input is square from Astable multivariate output(1 kHz square wave but a small spike appear on high to low signal) , then give to frequency divider , (why i divided the frequency because P &...
programmable gain amplifier using instrumentation amplifier & logic state control using demux...
if any problem in my circuit design plz help....
my circuit design in proteus ...
pga simulation not work... what problem tell me....then how i go for correct design.....:???:
- - - Updated - - -...
i try to design ecg simulator.......design oscillator for 1hz to 10khz....
find the ecg time interval used for calculated each p,t,qrs wave frequency.....
design frequency divider using d flip flop because of less noise....i choose d flip flop...
the different frequency is my input....of p wave...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
