Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hello all.....
I am using RCM4000 for the ethernet communication between PC and the kit. I have a .net application on my PC to send data on the ethernet port(of the PC). I have written a code in dynamic C to receive the data from the ethernet port but it is not showing the desired output. I...
pic gps code
I have already done it and this is working fine. But I have to store the received characters in an array so that i can perform some task on it.
can there be an issue of oscillator frequency for storing characters in the array????
or
is there any other method for storing received...
pic gps
I am working on GPS. i have to read the GPS data through PIC microcontroller and display it on hyperterminal (for example). I have written a code for it but i m not getting the GPS output. I m able to communicate with PC through keyboard. But when i connect the GPS receiver it is not...
how to interface 8051 with gsm modem
Thanks for your reply...
But i can't understand ..what is the significance of these connections?
Can you please elaborate it more.
gsm module pic microcontroller
this is the schematic of my hardware. Plz check it.
my modem supports 9600 bps. AT this baud rate it is responding with PC.
pic modem gsm
i m using a maestro modem which supports both text and PDU mode. and i m interfacing it with PIC 917.
i m able to send AT-commands using hyperterminal with the modem but when i communicate with the microcontroller, i m not able to get the response of AT-commands.
i m sending a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
