Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
We are using FPGA development board to get data from ADC and this board has USB 3.0 interface in device mode. We need to establish a USB 3.0 communication link with SSD(Solid state drive) which is also in device mode. We therefore need USB 3.0 host controller which stores data coming from FPGA...
Hi Mr. karthik,
But we are not using that port pin MOSI and MISO anywhere in the code. even if i change, it does not make any difference right? please go through the code once..
i have interfaced two p89v51rd2 micro-controllers configuring one as master and another as slave.
but i'm not getting any data and spi data transfer is not taking place. i used cro to check the spi clock signal but i'm just getting 5v dc signal. dont know what is the problem.
please anyone...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
