Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
since i am using a partial ground plane, I am simulating with 2 ports , one is the internal port and one is the reference ground port. In the manual of ADS, it states that there will be some difference in simulation results between using the internal port and single mode port, is it right for me...
I have designed a 3 band antenna and it gives good results in the ADS S11 simulation. However, when the antenna is fabricated and measured, one of the band only gives -6dB, but in the simulation results, it gives -20dB.
Are there any reasons about this problem so I can solve it ?
Many thanks~:cry:
i am working on a wideband antenna , i have searched some papers and i found that reduce the size of the ground plane is useful to make a wideband. but how does it work?
are there any theory to support the effect?
thanks very much~:grin:
i am using a partial ground plane for my antenna ( using layer cond2)
should i place a port on layer cond2 to ground it?
or only one port on layer cond for input is enough?
I am designing a multi band antenna and i use ADS to simulate it, i have some warning message when it simulating the S-parameters:
inaccuate (high frequency ) calibration;
electrically large via using lumped model;
higher order modes at the ports;
grouped strip-slot ports;
mesh density is too...
after i get the width, then i should adjust the length of the feed line until i get a good S11 results?
sorry for so many questions, i am new to antenna design, thanks so much!
the linecalc only calculate the width of feed line at one operating frequency,doesnt it?
however, my antenna is multiband, which frequency should i input ?will it work?
many thanks~!
50 ohm feed line calculation?
hello, i am working on a multiband antenna with subpatch, the main part of the anteena is finished but i dont know how to calculate the feed line dimension, and i just try the dimension one by one now, are there any efficient way that i can get the dimension?
i am...
I am working on a project which the main focus is to design a microstrip antenna in multiband ( wifi, GPRS, bluetooth)
as i am a beginner for antennas , what should i read or what should i do?
i have check it in the internet, but seems there are many different kinds of antennas, such as...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.