Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
You're right.
I'm new to logic design...
But where's this output enable signal?
Is it just the CMD line in the SD card?
Sorry for asking you too much and thank you!
- - - Updated - - -
It's quite useful. Right now, I just try to find where the test_o_en is for the SD card.
I think bidirectional bus operation is a problem because I was thinking I can only assign a line to be either input or output in FPGA's GPIO. If it's bidirectional, I would have difficulty to tell part when it works as an input line and when it works as an output line.
Thanks for sharing the...
Hi there,
Can FPGA read and write SD card in 4 bit SD mode?
The DAT[0:3] lines are bi-directional in this case.
It seems hard to deal with it.
Any ideas or should I purchase some written SD mode driver (where can I find it?)?
Many thanks!
New problem occurs.
DAT0 and CMD are bidirectional. Then how about the clock line and CS line? Can I just buffer these two lines through FPGA?
I tried to just buffer clock and CS line; it turned out that the computer could detect SD card, but it always ask to format the SD card.
I'm wondering...
Thanks!
- I'll try to connect Vcc and GND directly between two SD sniffiers.
- How can I tell which mode my computer uses? Ingnoring the FPGA, I once connected two SD sniffers together directly, i.e, computer<----SD sniffier(no sd card)<-----SD sniffer ( with SD card). And I found that only 5...
Hi Everyone,
I have one SD card, two SD Sniffers and an Actel Dev board. (Click for their products information)
What I wanna do is like this: insert one SD sniffer without a SD card into my computer, connect it to the FPGA board as input, then connect another SD sniffer with SD card to the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.