Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hey, thanks for taking to the time to look ay my post (:
I have attached a file which shows the question I am stuck on, and my attempt at working it out.
My problem is the answer I get, is different to what my Lecturer gets (shown in attachment). He worked it out a different way to me, he did...
Hello everyone, bellow shows a question with regards to micro-controllers which I am currently interested in, but stuck on, and need some (a lot) of help!
A boiler has an analogue inlet and outlet temperature sensor and the output controls
a valve in the gas supply to determine the heat input...
Thank you that did help!
So now I have my transfer function in the form:
And I understand that the function has one pole at
-1/R1*C
And one zero at
-1/R3*C
I wish to approximate the magnitude and phase response through a bode plot, but I am unsure on the next step, and some advice...
Thank you for you reply! :) I understand this is the form I need to get my equation into, but I don't fully understand how you did? If you would be as kind to elaborate, I would much appreciate it? :D
Thanks
1. The problem statement, all variables and given/known data
I have for the attached circuit measured the amplitude and phase response, but the question I have to answer is too theoretically, derive, similar results and then compare the two methods. It is suggested to figure out the transfer...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
