Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi friend thanx a lot for you help again i was on holiday and im back to try to resolve this problem :)
this ricoh has small pins to try to read voltage which type of probe do you use ? i will try to use my microscope to get pins correctly if you have some skills to read it without difficulty i...
hi friend yes of course the component marked on the red arrow isn't there actually.
about the green arrow there is no component too (no fuse) i post a picture with more detail (zoom).
thanx a lot for your help :)
hi friend thanx a lot for your help and your time again ;)
i follow my study about bip test result on the picture :)
i m suprised about the ac plug the original one coming from the mx box is 12v... i always working with during two or 3 years without until now
of course i ve seen the datasheet...
hi friend thanx a lot for your help first i test for you again the voltage output and it s 12.26v (pictures 1 and 2) i post too some information of the ac plug output voltage that i use for mx box (picture 3) i test too with othe ac plug with 5v output but i don t know if it s enough to start...
hi friend thanx a lot for you help and for your time first and i understand that you are busy ;) it s not a problem about the test of the end of plug i can measure it without problem
when i test it i have 12.26v at the end of the plug and test an other plug to be sure on this android box and...
hi friend sorry i was too busy with my work ...
so i take some measurement has you say to me you can see on the picture some measurement test.
about the melted plug it s was my fault because i try to desolder smd ceramic cap (red on the picture) to try to test it with hot air solder (not good...
Hi friend thanx a lot for your response about the blue one i never desolder something there it was original (normally which ic can we add?)
About continuity test do i need to test each side of resistance (red probe) and connector plug (black probe on front or back side (5pins) ?)
Thanx for help
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.