Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi everyone!
I'm trying to use the AMS hitkit 4.10 Cadence IC 6.1.7 on CentOS 7. Just after installation I created a new project in order to make sure the hitkit worked properly. I have set the model libraries and the simulation files in ADE L before launching the simulation.
When I launched the...
erikl: I don't think Cadence will start if the license is not valid.
BigBoss: I had Cadence Virtuoso installed on LM 32 bit. Linux Mint is a Ubuntu based distro,
Hi everyone!
I just installed Cadence Virtuoso and MMSIM under Linux Mint 18.1 64 bit. I have performed the installation following the instructions of the thread "Cadence Virtuoso and MMSIM installation". I want to specify that it's my second installation, first one performed in 64 bit...
Hi everyone!
I'm having the following problem.
Referring to the circuit attached, a simple voltage amplifier in non inverting configuration, I have to evaluate the impedance at the node V2 and V0 when a large signal is applied at the node V1.
R2 is 580K and R1 is 5.8K, thus the theoretical...
Just want to notify everyone that I solved the problem! Using the solution provided from erikl, I took a deep view to the AMS Hitkit 4.10 documentation page. I followed the steps illustrated in the document 'Safe Operating Area Check'. You just need to add all the required .scs files in the...
Hi, I'm not sure how to do that. I'll show you my ams installation directory
Now If I add in ADE->setup->model library all the files .scs contained in the folder spectre in my installation directory the output log menu when trying to simulate gives me that:
Am I wrong again? What is the filename...
Hi everyone! I'm trying to simulate a simple voltage amplifier made using models from AMS Hit Kit 4.10 (ams 0.35 um) in Cadence IC 6.1.5.500.15.
When I try to simulate the circuit using ADE L and spectre as simulator I got this error in the Output log menu. (See attachments)
Where MP and MN are...
For what concerns about my previous post I would like to tell the community that I was finally able to make a successful installation on Debian Wheezy 7.5. I've also tried to install on Xubuntu 14.04 and Linux Mint 17 Cinammon and worked perfect too. Just follow the instructions on the posts #1...
Hi, after having read the post about the installation of Cadence Virtuoso IC615 and MMSIM on Debian I decided to try to install on my pc.
I have Debian Wheezy 7.5 installed and followed precisely the steps in the post #1 for the installation and in post #7 and #77 for the specific consideration...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.