Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: Question how to interface 8051 with the 4x4 matrix keypa
it is easy. you can scan row or colum and remember a phenomenon "lap" or "ring" keypad. you need delay about 10ms and scan another one.
Re: master/slave 8051
y can conect up to xxx notes. If you using a repeter( because rs485 permit maximum 32 note.It depend on Rt resistor tranmit line and reflection of signal.)
Re: interfaching rs485
you can use max485 for project. there much noise in transmit line so that you have to reduce it.
Added after 8 minutes:
I'm designing Board RTU using atmega128 and interfaching some slave with another. I have to build protocol for this network and i have some...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.