Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello
I'm trying to simulate an antenna that I have found on the internet. I'm trying to get the same values for it withe Microwave, but it dosen't work very well.
I put my settings in the rar file and I hope someone could take a look and give me some feedback where my misstakes are.
Regards...
Hello Guys!
I tried to simulate an antenna which picture I attached below with MW Office. I have a few problems with that. Could you guys take a look on it, and give my some feedback.
https://obrazki.elektroda.pl/63_1289567344.jpg
https://obrazki.elektroda.pl/85_1289567452.png...
hello manju
how can I coupling coils with Mw Office constitute,,I have so tries but it does not work the,,how do you do that I hope you have some time to help me
thank you many times
I hope that I am now wide
---------- Post added at 16:20 ---------- Previous post was at 15:24 ----------
The question now,,if I now Here are some of reel change, then stops working,I need something bigger coil working as antenna coil.
the chip supplied with energy.
so...
AWR Microwave Office help
Hello!
I do not have much experience with MV AWR office if someone could help, I'll be grateful,
Coupling between coils in the near field UHF range,
I will post a photo below what I have done already in MWO EM Structure
I'll be grateful for all help I can get to...
Hello !!
I hope you guys can help me!
I wanna simulate an antena in AWR MW-Office like the antenna in the PDF-file I uploaded with this post.
Something like that:
3x3 mm, 4 x turns, conductor
thickness of 0.4 mm spacing between turns 0.4mm
Who could I do that? Maybe someone can send me an...
Hello!
I do not have much experience with MV AWR office if someone could help, I'll be grateful,
Coupling between coils in the near field UHF range,
I will post a photo below what I have done already in MWO EM Structure
I'll be grateful for all help I can get to simulate this.
How can I draw...
Hello!
I do not have much experience with MV AWR office if someone could help, I'll be grateful,
Coupling between coils in the near field UHF range,
I will post a photo below what I have done already in MWO EM Structure
I'll be grateful for all help I can get to simulate this.
How can I draw...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.