Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
S to RLGC in ADS (S2RLGC in MATLAb)
I have S-parametrs(S11,S12,S21,S22) for line in my topology - calculated in ADS "momentum",
how I can get out of them "RLGC line parameters" in ADS ?
(in MATLAB - "S2RLGC" function)
ADS have:
schematic->tools->spice model Generator-> Narrow Band Generator...
I want understand how to calculate V2 on TERM2(Z2=1000 ohms) if S21 = 0.425 ?
for example, HB and transient analysis give results, in which NO reflections(HB_TR_sim2.jpg HB_TR_sim_res2.jpg see above)
and V2 = 0.952 -> This is understandable and it's true.. (1*[1000/1050]=0.952)
on the...
- generator with an output impedance of 50 ohms
- chip with an input impedance of 1000 ohms (at 100 MHz)
- microstrip line on PCB, and its S-parameters in ***.S2D file
why? simulation in ADS gives mag(S21) = 0.424 (and not seek to 1)
for example, harmonic balance and transient analysis give...
I have a PCB(test bench), which has "contacting device"(Socket) to holds the ICs(without soldering).
The "contacting device"(Socket) consists from "pins". Effect of these "pins" I want to consider when simulating PCB in ADS.
I have a graphics S21 and S11. And
Self Capacitance of pin: 0,47 pF...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
