Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have a question about FPGA ,I use boundary scan of ISE to find Xilinx FPGA and its configuration chip and ISE can’t identify them, But I find that ISE can work well as long as I use the probe of oscillograph to contact TDO pin of FPGA, is it because the impedance of probe impact on the...
I'd like to calculate cross correlation of two sets of data which have 3300 12-bit samples respectively.but i don't know how much MAC i need, because i have to determine which type of cylcone2 for my development in terms of the amount of MACs thank you!
thank you for your reply,the input of this circuit is the coil L1 which induces a transient changing magnetic field , a transient current changing occurs in the coil and i want to amplify this signal, from my experiment,when there is no changing magnetic field the current across L1 is unvaried...
I design a circuit which is shown below,and it works
,but i don't know how to analyse it is kinda different with the basic differential circuits L1 is coil which is used to induce a changing magnetic field and i'd like to ampilify the induced current signal which is very small ,about 75mV(P to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
