Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi antedeluvian
Thanks for the help. Yes, it is a 0.3" wide 28-pin DIP. The pinouts don't match any chip from Atmel, Microchip, Freescale, Philips or ST, and from the info you provided it seems to be a Cypress PSoC chip.
Hi polymath
Your suggestion about the 28-pin module board is a good idea...
28pin 8051
The customer has a few faulty units in which all circuit seems to be OK except the microcontroller. In order to get them working again, he wants to replace the faulty micros by a new one. The company from where he purchased the instruments has closed down. So no support is available...
identify microcontroller
fenugrec wrote:
There is no external crystal. VDD is 5 V.
The pinouts don't seem to match any of the PIC or AVR devices.
Any help in identification will be appreciated.
28 pin microcontroller
Hi all,
I got an assignment to develop program for a 28-pin DIP type package microcontroller. The hardware is already designed and assembled but the microcontroller is damaged.
The number on microcontroller has been scraped off. Only info about microcontroller I could...
rf modules serial
Munib wrote in original message:
I believe the problem is being caused by the output device in transmitter or input device in receiver going into saturation when a 0 is sent ( transistor is switched on for a 0 ) and it takes time to come out of saturation when the first 1 is...
microcontroller ic for noisy and emi environment
Thanks IanP for providing link to Maxim's microcontroller info. It seems to be a good microcontroller.
I understand that it has an option of switching off ALE, when not needed, to reduce noise emissions.
However, I want to know, how good is it...
how shielding to reduce noise for microcontroller
Hi all,
I need a microcontroller with following features for an industrial control project:
- Flash memory > 32 K bytes
- 2 UARTs
- 1 synchronous serial port such as SPI
- support for external RAM interface
- 5V supply voltage
- excellent...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.