Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Sometimes, a picture is all that is required for someone who admits they know very little....
Have a look at Figure 1 in the link below:
https://cnx.org/content/m22648/latest/
Re: PIC Program needed
Even though the LED is incorporated in the switch, there should be separate terminals for the LED in SW1. Check the switch terminals with an Ohm meter and determine the actual switching contacts Vs the LED terminals.
If you can provide a link to the actual switch you...
Re: PIC Program needed
Unless I am missing something from your schematic, SW1 would need to latch in order for D2 to be illuminated along with D1 (assuming a working program). This would involve reading GP4 (IC Pin #3... incorrectly labelled as GP3.....) firstly as input, de-bouncing and then...
embeddedice
ICE is also a term used for In Car Entertainment.
Whether it pertains to OP's question is subject to clarification, but some of the guys over at MP3Car.com forums - **broken link removed** - seem to be using PIC's etc. now and again.
HTH.
Another option that has been used, requires modification to the motor case/bearing at the shaft end. The original bearing is removed and discarded, the case enlarged to accept a larger bearing with a larger I/D, a sleeve is then used to route the wires between the bearing and the armature and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
