Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Ok here is a screenshot from my Altium schematic - I've put where I connected the probe and where I've put the capacitor. The actual ledstrips are not shown in the picture but they are 12V and powered from a lab power supply on a seperate ground line. The connection between the two grounds is...
I'm working on a LED Strip controller project and I use the PCA9685 as PWM generator and now for test purposes I use a standard Arduino board as microcontroller. However on an oscilloscope I notice there are voltage spikes on the VDD pin of around 200mV each time the level of a PWM output...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.