Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks, BradtheRad. I now get a Dot beam when I disconnect the CRT tube pin 3 cable from the H.V psu circuit, the beam only disappears when I put it back. With the Dot beam on the screen, all the control knobs work fine but I can not get the beam to sweep horizontally on the screen not matter...
I bought Leader LBO-514A Oscilloscope, it powers on but no Trace at all. I opened it and checked the PSU voltages.
Right now, all the required voltages for Scope to work are present (ie -15,+15, 250v, 1750V HV) but still no trace . I only see a DOTTED Light which flash ONCE upon switching...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.