Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all,
I'm using a high voltage diode in my project.(the part's shown in below picture)
But i can't purchase it anymore from the market because it's an obsolete part. So i'm looking for an alternative part.
Does anyone know which part can replace this one?
Any susgestion will be much...
Hi all,
I create a simple project to change the start time of DS1307 using I2C interface and PIC16F877A is the master!
But when i start the simulation. The time in DS1307 always starts at 00:00:00 , it doesn't change anything.
Any suggestion?
Thank you!
The source code was written by...
Hi guys.
I have a PADS .pcb binary type and i have tried to import it using Altium import wizard. But Altium just supports ACSII PADS files.
I wonder if there is any free soft can convert it for me?
Thanks in advance for any suggestion!
Hi loosemoose,
I tried your method, the pcb looks more precise. But if the number of component increases, i could not place them one by one. Does any body know an automatic way?
Thanks for your help!
Hi all,
Could u kindly help me to solve these two problem?
1. I import an step model to define a circular board shape and place components as the picture below.
I manually rotated component and place them one by one.
I wonder if Altium has any tool supporting this kind of placement?
2...
Hello,
I have a SMD device which has the code APW , 712B, XJB1W and has 8 pins. I have looked up in some SMD code book but i can't figure it out.
Anybody know which device these code stand for?
pcb file
In Orcad, i have tried to import the .pcb file as Protel PCB, Tango PCB,... but Orcad said that it's neither Protel or Tango PCB file. I have also googled the header but i couldn't find out the result.
Anybody help me?
Hi guys,
I have a .PCB extension files and i tried to import it to Altium 09 and Orcad layout 10 but it did not work. So i guess it isn't an protel pcb file.
I opened it by notepad and the header is "00 FF 17 20 02 00 00"
Does anybody know which design tool can open that file?
Many thanks,
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.