Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i'm not sure.. but you can try to measure the losses for your spliced SMF/MMF combination trials
Actually, the low loss (0.2-0.3dB) were even measured for non-spliced but close fibers (or better to use a lensed SMF placed at half the working distance) that's why i assume your case will be as...
I think it's okay to have a pigtailed MMF spliced or connectorized to your SMF configuration.
In fact, most if not all the pigtailed detectors, as far as i know, use MM. This is because losses from single-mode to multi-mode fibers by splicing are about 0.1-0.2dB
The opposite of course is not...
phase unwrapping matlab
Hi,
Does anyone have a 2D-phase unwrapping MATLAB code?
the unwrap command in matlab is only 1D and does not work fine with noisy phase images
Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.