Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi everybody,
I used op-amp for my project. And supplied with +12 and -12 volts. My PCB will have 4 layers which are TOP (signal layer) ,POWER (internal plane),GROUND(internal plane),BOTTOM (signal layer). When i split the power plane for supply voltages such as +12V, +5V , +3.3V , i confused...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.