Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi guys.
Unfortunately, my attempts to find the "A4911" Allegro BLDC driver datasheet was unsuccessful.
To get the datasheet you must contact the Allegro company. I emailed them twice but unfortunately received no response.
There is a brief datasheet on the Internet, but I need a complete...
I was not familiar with the Incremental implementation before. Using it, the implementation time was reduced by half. It was a great experience for me.
Based on my searches and studies It is recommended for when the design changes are below 5%
Thanks a lot.
1626684064
Thanks a lot...
Hi guys
I have an RTL design project in the VIVADO 2020 developing environment, and my implementation platform is ARTIX 7.
In my project, I have about 30 trusted and tested VHDL files and cores without the need to change. I always change one of the VHDL files and do not change the other files...
I have 4 binary files read backed from EEPROMs.
I used "XELTEK SUPERPRO 3000U" programmer to read back EEPROMs, but I did not find any option or tools to merge horizontally these files.
Hi
I am working on a reverse engineering project based on the MC68020 Motorola 32Bit processor. The program is stored in 4x8Bit EEPROM as the instruction memory. However, my EEPROMs only have 8bits data output, but I want my instructions to be 32bits long.
How can I combine these four binary...
I am involved in a reverse-engineering project that includes an MC68020 processor. I am an electronic engineer and
I don't have enough experience for reverse-engineering of the processor programs.
Please help me convert binary code to assembly.
Thanks a lot.
Hi guys
anyone here can help me to find a binary file to the assembly file (Disassembler program) for the MC68020 (68000 series) Motorola processor.
Thanks a lot
Hi
I have recently started to design a custom schematic based on Zynq7000 FPGAs. For better attitude toward Zynq7000 hardware design , I have searched in many sample boards produced by Xilinx Co. In many of them two types of DDR3 memory are available , one for PS and another one for PL.In most...
Hi
I am trying to export my gerber files from an Altium PCB project .My board dimensions is 960mm x 45 mm (it’s a long board with strange dimension). In File>Fabrication output>Gerber Files> Advanced Tab I have changed Film size options (X,Y) with large enough numbers (Like 1000mm or 2000mm).But...
Hi everybody
I tried to implement a very simple Microblaze hardware on my custom board based on XC3S400 FPGA. But in the first step of developing code in the SDK environment I have faced with a strange error; after exporting my platform into the SDK environment and before any build command or...
Hi
I am trying to connect a 16MB SPI Flash Memory (SST25VF016B) to one of SSP buses in LPC1788 but after some studies in LPC1788 datasheet I realize that the Address length in SSP bus can vary only between 4 to 16 Bits. Obviously I need 24 Bit address length in my application. In your point of...
Yes,even i captured my serial port with "HHD Free Serial Port Monitor" software, and i saw my request string was correct.
Serial port monitor showed my request string was:
2A 49 44 4E 3F 0A
that's equal with:
*IDN?<LF>
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.