Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello, I am looking for people to write about the soldering irons and soldering in general. About 500 word per article. Need many of them. The articles need to go through plagiarism check. If you are interested in this job or have any question, private message me within the site.
I will design the following two circuits. One is booster converter(?) with inductor(off chip). the other one is 2X charge pump with fly cap. Can you please suggest any practical reference to start with? For example, how to analyze its efficiency and its output equivalent load...
I read...
Hi,
The version I am using is Cadence IC 4.4.6. In spectre(standalone), I might use .IC to write the initial condition voltage to the nodes. That's the only thing I know. I did not use spectre since it is really advanced for me. But I know it give more power and flexibility in simulation...
Hi everybody,
I have some problems about the initial condition setting with SpectreS.
What I have is memory array with 1024 cells. I would like to initialize
each cell with either 1 or 0.
With SpectreS, the only way I know is to use the convergency option and
then click the node. Is there any...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.