Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all,
I need a help to combine two projects from CST Studio 2011 and AWR Design Environment. I have no idea how to
combine together. Is possible to export antenna to AWR and change instead of 50ohm resistor in my AWR simulation and also
use the uwb RF generator in CST to see how works...
Hi,
I'm looking for any examples in Matlab or Simulink for the UWB m-sequence radar.
I have started with generating m-sequence, but I can figure out how to generate the final output sequence... and how to detect that on
the RX side?
thanks for answers
Hi,
I found the sample on the page of NI:
Understanding Spread Spectrum for Communications - Developer Zone - National Instruments
and if simulate the same thing in matlab and simulink I got the different result, can anyone please tell me where is the catch.
I put the PN sequence generator and...
Hello,
I'm trying to generate m-sequence with PN sequence generator in simulink. I used
polynome 3 1 0 and start sequence 0 0 1
after that I'm trying to test the autocorrelation but the expected signale is complety wrong
What i'm doing wrong any help please?
What about if we change PORTD to (DB7-DB4 LCD to PORTD4-7) and E, RS to Portd2 and protd3 where are the changes in this code you attached M1ANH?
Thanks
I tried to connect Vout with pull-down resistor on ADC of Pic16f877 and
two diodes serial 1n4148 on GND pin to make offset.
I tried to measure temperature for about -5°C and the result are always +2 to +3
what can i do to measure the correct temperature?
the equation is the next:
Temperature =...
Hi I'm trying to convert this function from CCS:
byte crclo, crchi;
void crcBit(byte tbyte) {
#asm
BCF 03,0
RRF crchi,F //rotates the entire 16 bits to the right
RRF crclo,F
#endasm
if (((STATUS & 0x01)^(tbyte)) == 0x01) {
crchi = crchi^0x84;
crclo = crclo^0x08;
}
}
to Hi-tech...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.