Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hey thanks for replying
im sorry i made a mistake
the 4th pin of opamp is not ground it is -5v.(attached a photo again)
so now it makes sense to operate from 0 to 5v?
and im sorry i dont have a datasheet or circuit for this
but im attaching individual components datasheet to it
thank u and...
firstly I'm new to electronics project with some basic knowledge.
My project is "DAC controller"
The device is used to adjust the output voltage or current ( in that respective mode,the device works for both modes) based on the input vltg or current . ie as input raises the output should drop...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
